LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Hybrid/EV Controls) >> Diagnostic Information and Procedures >> DTC P0C0B or P0C0E >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Vehicle ON.
  2. Verify DTC P0C0B or P0C0E is not set.
    • If any of the DTCs are set 
    1. Clear the DTC, vehicle OFF for 2 minutes to allow all control modules to shut down.
    2. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
    3. Verify the DTC does not set.
      • If the DTC sets, continue to Circuit/System Testing.
      • Go to next step: If the DTC does not set.
    4. All OK
    • Go to next step: If none of the DTCs are set 
  3. All OK
scientia non olet · About LEMON Manuals