Circuit/System Verification

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Vehicle ON.
Verify DTC P0562 is not set.
- If the DTC is set
  Refer to DTC B1325, B1330, B1424, B1425, B1439, B1517, C0800, P0560-P0563, P1002, P129B, P129C, P15AE, P15AF, P1A0C, P1A0D, P17B0-P17B2, P17DD-P17DF, P1E19, OR P1E1A .
- Go to next step: If the DTC is not set

NOTE:

Ensure the DTC is set within the Hybrid/EV powertrain control module 1 or drive motor control modules. See Diagnostic Aids.

Verify DTC P0601, P0602, P0603, P0604, P0606, P062F, P1EB6, or P1EB7 is not set.
- If any of the DTCs are set
1. Verify the T6 Power Inverter Module has the latest calibration in Calibration Information.
  - If the T6 Power Inverter Module does not have the latest calibration, program the T6 power inverter module.
  - If the T6 Power Inverter Module has the latest calibration, replace the T6 Power Inverter Module.
2. Verify the DTC does not set.
  - If the DTC sets, replace the T6 Power Inverter Module.
  - Go to next step: If the DTC does not set.
3. All OK
- Go to next step: If none of the DTCs are set
All OK