LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Hybrid/EV Controls) >> Diagnostic Information and Procedures >> DC Power Conversion Test >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Vehicle OFF.
  2. Measure and record the C1 battery voltage at the C1 battery terminals. The C1 battery voltage should stabilize between 12.4 and 12.8 V within a few minutes of turning the vehicle OFF.
    • Go to next step: If within the specified range 
  3. Vehicle ON, accessories OFF.
  4. Measure and record the C1 battery voltage at the C1 battery terminals. The voltage should be at least 1 V greater than the voltage measured in step 1 but less than 15.6 V.
    • If not within the specified range 

      Refer to Circuit/System Testing.

    • Go to next step: If within the specified range 
  5. All OK.
scientia non olet · About LEMON Manuals