Installation Procedure
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- NOTE:
Clean and lubricate the exhaust isolators for ease of installation.
Exhaust Muffler Assembly (2) - Install
- Exhaust Muffler Isolator (1) - Connect
Exhaust Gasket (2) - Install NEW
- Exhaust Muffler Assembly (3) Install
- Exhaust Front Pipe Nut (1) - Install and tighten [2x] 22 N.m (16 lb ft)
Floor Panel Tunnel Panel Front Brace (2) - Install - Floor Panel Tunnel Panel Front Brace Replacement
- Lower the vehicle.
- Start the engine and check for exhaust leaks.
CAUTION:
Refer to Fastener Caution .