Circuit/System Verification
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Vehicle in Service Mode.
- Verify the scan tool EVAP Leak Detection Pump Switching Valve Output parameter does not display Malfunction when commanded to Venting or Not Venting.
- If Malfunction is displayed
Refer to Circuit/System Testing.
- Go to next step: If Malfunction is not displayed
- If Malfunction is displayed
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Refer to Circuit/System Testing.
- Go to next step: If the DTC does not set
- If the DTC sets
- All OK.