Conditions for Setting the DTC
P145C
The EVAP leak detection pump is commanded ON during the first reference orifice vacuum measurement and the stabilized EVAP leak detection pump pressure sensor vacuum reading is less than 0.1 kPa (0.01 PSI) for greater than 6 min.
Or
The EVAP leak detection pump is commanded ON during the second reference orifice vacuum measurement and the stabilized EVAP leak detection pump pressure sensor vacuum reading is less than 0.1 kPa (0.01 PSI) for greater than 30 s.
P145D
The EVAP leak detection pump is commanded OFF for the first time and the EVAP leak detection pump switching valve has transitioned from vent to not venting, pump position. The difference between an initial EVAP leak detection pump pressure sensor reading and a second EVAP leak detection pump pressure sensor reading is greater than 1 kPa (0.14 PSI) for greater than 8 s.
Or
The EVAP leak detection pump is commanded OFF for the second time and the EVAP leak detection pump pressure sensor vacuum reading is greater than 1.18 kPa (0.17 PSI) for greater than 14 s.