Conditions for Setting the DTC
P0451
The ECM detects the difference between the fuel tank pressure sensor and the EVAP leak detection pump pressure is greater than 0.747 kPa (0.11 PSI) for greater than 0.1 s.
P0452
The ECM detects the fuel tank pressure sensor voltage is less than 0.15 V for greater than 0.01 s.
P0453
The ECM detects the fuel tank pressure sensor voltage is greater than 4.85 V for greater than 0.01 s.
P0454
This DTC will detect intermittent tank vacuum sensor signals that would have caused the EVAP leak detection pump small leak test to abort due to an apparent re-fueling event.
P1464
The passive portion of the diagnostic runs when the propulsion system goes active, the vehicle has soaked for a minimum amount of time, the EVAP leak detection pump vacuum pump has been off for a minimum amount of time, and purge is not enabled.