LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 49 (Engine Controls And Fuel - 1.8L (LKN) - DTC P0010-DTC P0459) >> Diagnostic Information and Procedures >> DTC P0090-P0092, P00C8, P00C9, or P00CA >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition/Vehicle Off, disconnect the harness connector at the G18 High Pressure Fuel Pump.
    NOTE:

    The following tests require the DMM and test leads must be calibrated to 0 Ω in order to prevent misdiagnosis.

  2. Test for 0.3 - 0.7 Ω at 20°C (68°F) between the high control circuit terminal 1 and the low control circuit terminal 2.
    • If not between 0.3 - 0.7 Ω 

      Replace the G18 High Pressure Fuel Pump.

    • Go to next step: If between 0.3 - 0.7 Ω 
  3. Test for infinite resistance between each terminal and the G18 High Pressure Fuel Pump housing.
    • If less than infinite resistance 

      Replace the G18 High Pressure Fuel Pump.

    • Go to next step: If infinite resistance 
  4. All OK