Component Testing

Static Test

1. Ignition/Vehicle - Off
2. Disconnect the appropriate electrical connector:Q6 Camshaft Position Actuator Solenoid Valve
3. Test for 5 to 12 ohms between the test points:Control circuit terminal 2/B & Low Reference circuit terminal 1/A
   • If not between 5 and 12 ohms 

     Replace the component:Q6 Camshaft Position Actuator Solenoid Valve

   • Go to next step: If between 5 and 12 ohms 
4. Test for infinite resistance between the test points:Each terminal of the component & The component's housing
   • If less than infinite resistance 

     Replace the component:Q6 Camshaft Position Actuator Solenoid Valve

   • Go to next step: If infinite resistance 
5. All OK.

Dynamic Test

1. Ignition/Vehicle - Off
2. Disconnect the appropriate electrical connector:Q6 Camshaft Position Actuator Solenoid Valve
3. Connect a jumper wire between the test points:Low Reference circuit terminal 1/A & Ground
4. Momentarily connect a 7.5 A fused jumper wire between the test points:Control circuit terminal 2/B & B+

   Verify the component turns On and Off when connecting and disconnecting the jumper wire:Q6 Camshaft Position Actuator Solenoid Valve

   • If the component does not turn On and Off 

     Replace the component:Q6 Camshaft Position Actuator Solenoid Valve

   • Go to next step: If the component turns On and Off 
5. All OK.