Rear Bumper Fascia Replacement

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Rear Wheelhouse Liner Replacement Underbody Rear Air Rear Deflector Replacement (LFV, LKN)
1	Rear Bumper Fascia Bolt [2x] CAUTION: Refer to Fastener Caution . Tighten 2.5 N.m (22 lb in)
2	Rear Bumper Fascia Nut[2x] Tighten 2.5 N.m (22 lb in)
3	Rear Bumper Fascia Retainer[2x]
4	Rear Bumper Fascia Procedure Carefully push a small nylon wedge between the fascia and the rear fascia guide. Insert a small flat-bladed tool into the fascia slot and depress the snaps one at a time and pull on the fascia at the same time to gradually remove the fascia from the rear fascia guide. Disconnect all electrical connectors. Transfer components as necessary.