Rear Side Door Accessory Switch Mount Plate Replacement

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Rear Side Door Armrest Pull Cup Bolt Cap
2	Rear Side Door Armrest Pull Cup Fastener CAUTION: Refer to Fastener Caution . Tighten 2.5 N.m (22 lb in)
3	Rear Side Door Accessory Switch Mount Plate Procedure Using a flat-bladed plastic trim tool, start at the front of the accessory switch mount plate and gently insert trim tool to lift the rear side door accessory switch mount plate from the door trim assembly. Disconnect the electrical connector. Transfer components as necessary.

Callout

Component Name

Rear Side Door Armrest Pull Cup Bolt Cap

Rear Side Door Armrest Pull Cup Fastener

CAUTION:

Refer to Fastener Caution .

Tighten
2.5 N.m (22 lb in)

Rear Side Door Accessory Switch Mount Plate

Procedure

Using a flat-bladed plastic trim tool, start at the front of the accessory switch mount plate and gently insert trim tool to lift the rear side door accessory switch mount plate from the door trim assembly.
Disconnect the electrical connector.
Transfer components as necessary.