LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (Lighting System - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Hazard Lamps Malfunction >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition - On / Vehicle - In Service Mode
  2. Hazard Warning Switch - On and Off

    Verify the scan tool parameter:Hazard Warning Switch = Active/Inactive

    • If the parameter state does not change 

      Refer to: Circuit/System Testing

    • Go to next step: If the parameter state changes 
  3. Hazard Warning Switch - On and Off

    Verify the component activates:Hazard Lamps = On and Off

    • If not the specified state 

      Refer to: Circuit/System Testing

    • Go to next step: If the specified state 
  4. Scan Tool Device Control - Backlight Dimming - On and Off

    Verify the component activates:Backlight Dimming = On and Off

    • If the component does not activate 

      Refer to: Circuit/System Testing

    • Go to next step: If the component activates 
  5. All OK.
scientia non olet · About LEMON Manuals