Circuit/System Verification

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Ignition - On / Vehicle - In Service Mode
Verify the scan tool parameter:Automatic Headlamps Disable Switch = Inactive
- If not the specified state
  Refer to: Circuit/System Testing
- Go to next step: If the specified state
Operate the component:S30 Headlamp Switch - Off
Verify the scan tool parameter:Automatic Headlamps Disable Switch = Inactive
- If not the specified state
  Refer to: Circuit/System Testing
- Go to next step: If the specified state
Verify the scan tool parameter:Park Lamps = Inactive
- If not the specified state
  Refer to: Circuit/System Testing
- Go to next step: If the specified state
Operate the component:S30 Headlamp Switch - Park Lamps
Verify the scan tool parameter:Park Lamps = Inactive
- If not the specified state
  Refer to: Circuit/System Testing
- Go to next step: If the specified state
Verify the scan tool parameter:Headlamps On Switch = Inactive
- If not the specified state
  Refer to: Circuit/System Testing
- Go to next step: If the specified state
Operate the component:S30 Headlamp Switch - Headlamp
Verify the scan tool parameter:Headlamps On Switch = Active
- If not the specified state
  Refer to: Circuit/System Testing
- Go to next step: If the specified state
All OK.