LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Wiring Systems And Power Management - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P305B or P305C >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF/Vehicle OFF, and all vehicle systems OFF, disconnect the X1 harness connector at the T19 Power Supply Transformer.
  2. Test for less than 1 V between the ignition circuit terminal 6 and ground.
    • If 1 V or greater 

      Repair the short to voltage on the circuit.

    • Go to next step: If less than 1 V 
  3. Ignition ON/Vehicle in Service Mode.
  4. Verify a test lamp illuminates between the ignition circuit terminal 6 and ground.
    • If the test lamp does not illuminate and the circuit fuse is good 
    1. Ignition OFF/Vehicle OFF remove the test lamp.
    2. Test for less than 2 Ω in the ignition circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, refer to Power Mode Mismatch .
    • If the test lamp does not illuminate and the circuit fuse is open 
    1. Ignition OFF/Vehicle OFF remove the test lamp
    2. Test for infinite resistance between the ignition circuit and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
    • Go to next step: If the test lamp illuminates 
  5. Replace the T19 Power Supply Transformer.
scientia non olet · About LEMON Manuals