Circuit/System Verification
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition - On / Vehicle - In Service Mode
- Operate the component:Parking Assist Switch - Cycle On and Off
Verify the scan tool parameter:Parking Assist Switch = Active/Inactive - The value should change when selecting the different switch positions.
- If not the specified values
Refer to:DTC B0967 or B0968
- Go to next step: If the specified values
- If not the specified values
- Engine running, parking brake applied, transmission in R.
- Verify the component is activated:Backup Lamps = On
- If the backup lamps are not illuminated
Refer to:Backup Lamps Malfunction .
- Go to next step: If the reverse lamps are illuminated
- If the backup lamps are not illuminated
- Verify the scan tool parameter:Parking Assist System Status = Enabled
- If the parameter does not display the following:Enabled
Refer to:Parking Assist Description and Operation (UD7) Parking Assist Description and Operation (UFQ)
- Go to next step: If the parameter displays the following:Enabled
- If the parameter does not display the following:Enabled
- All OK.