LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Automatic Transmission - VT40 (MRG) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Mount Strut Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM5109529Courtesy of GENERAL MOTORS COMPANY

    Position the transmission rear mount bracket to the vehicle. (3).

    2. CAUTION:

    Fastener Caution

    CAUTION:

    Torque-to-Yield Fastener Warning

  2. Install and tighten the 4 NEW transmission rear mount bracket bolts (2).
    1. First Pass:100 N.m (74 lb ft)
    2. Final Pass:60 - 75 degrees
  3. GM5109529Courtesy of GENERAL MOTORS COMPANY

    Install and tighten the NEW transmission rear mount bolt (1).

    1. First Pass:70 N.m (52 lb ft)
    2. Final Pass:90 - 105 degrees
  4. Remove the jack stand.
  5. Lower the vehicle. Lifting and Jacking the Vehicle
scientia non olet · About LEMON Manuals