Automatic Transmission Fluid Pressure Sensor Replacement
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| Preliminary Procedure Automatic Transmission Wiring Harness @ Transmission - Remove - Automatic Transmission Wiring Harness Replacement |
|
| 1 | Control Valve Body Bolt [2x] M5 x 98.3
CAUTION:
Tighten 8 N.m (71 lb in) |
| 2 | Control Valve Body Bolt [2x] M5 X 85 Tighten 8 N.m (71 lb in) |
| 3 | Automatic Transmission Fluid Pressure Sensor [2x] Procedure After repairs, refer to Control Module References for programming and setup. |
| 4 | Automatic Transmission Fluid Pressure Sensor Seal [2x]
NOTE:
Install a NEW seal. Do NOT reuse the old seal. |