Installation Procedure
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- NOTE:
Engine Control Module Bracket removed for clarity.
Install the left transmission mount (5) to the vehicle.
- Transmission Mount Bolt (4) - Install and tighten [2x] 100 N.m (74 lb ft)
- Transmission Mount Transmission Side Bolt (3) - Install NEW and tighten [4x]
- First Pass:100 N.m (74 lb ft)
- Final Pass:60-75 Degrees
- Position the transmission mount bracket (2) to the vehicle.
- Engine Mount Brace Bolt (1) - Install and tighten [2x] 22 N.m (16 lb ft).
- Remove the transmission jack.
- Install the Engine Wiring Harness Fuse Block Bracket. Engine Wiring Harness Fuse Block Bracket Replacement
- Install the battery tray. Battery Tray Replacement (LTG)
CAUTION:
Refer to Fastener Caution .