Installation Procedure
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Install the transmission control lever knob (3) to the transmission control lever.
- Connect the park brake switch electrical connector.
- Insert the rear locating tab (2) into the front floor console.
- Seat the front retainer (1) of the bezel into the front floor console.
- Turn the ignition switch to On position, engine Off.
- Place transmission control in the Park position.
- Un-apply the parking brake.
- Turn the ignition switch to the Off position.
NOTE:
Pull up on the shift knob after installation, to ensure the knob clip is locked in place.