LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Automatic Transmission - 9T50 (M3E) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Automatic Transmission Input Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM4487717Courtesy of GENERAL MOTORS COMPANY

    Install the input speed sensor seal (3).

  2. Install the input speed sensor (2).
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the input speed sensor bolt (1) and tighten to 9 N.m (80 lb in).
  4. Connect the input speed sensor electrical connector.
  5. Install the left front wheel house liner. See FRONT WHEELHOUSE LINER REPLACEMENT - LEFT SIDE .
  6. Perform the transmission service fast learn procedure. Transmission Service Fast Learn Procedure .
scientia non olet · About LEMON Manuals