Installation Procedure
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Camshaft Position Sensor (2) - Install
- Camshaft Position Sensor Bolt (1) - Install and tighten 10 N.m (89 lb in)
Electrical Connector (1) @ Camshaft Position Sensor (2) - Connect
- WARNING:
After installing the transmission range selector shift cable, pull up and push down on ALL connections to verify that the connections are fully seated and properly engaged. Failure to perform this task can result in the vehicle not being able to shift into PARK causing potential vehicle damage and bodily injury.
Install the transmission range selector lever cable (2) to the cable bracket.
- Connect the transmission range selector lever cable terminal (1) to the transmission manual shift lever pin.
- Adjust the automatic transmission range selector lever cable. RANGE SELECTOR LEVER CABLE ADJUSTMENT
- Intake Manifold Cover - Install - Intake Manifold Cover Replacement
CAUTION:
Refer to Fastener Caution .