Installation Procedure
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- NOTE:
Lubricate the NEW vacuum pump seal with clean engine oil before installing to the special tool.
Install the NEW vacuum pump seal (1) to the DT-45866 installer (2).
- NOTE:
- The vacuum pump seal must NOT deform during the installation procedure.
- Ensure the vacuum pump seal is FULLY seated into the camshaft cover.
Use the DT-45866 installer to install the NEW vacuum pump seal (1) into the camshaft cover.
- Vacuum Pump Assembly - Install - Vacuum Pump Assembly Replacement