LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Disc Brake System) >> Repair Instructions >> Rear Brake Caliper Replacement (Without J71) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM4231221Courtesy of GENERAL MOTORS COMPANY

    Brake Caliper (1) - Install

  2. GM4231220Courtesy of GENERAL MOTORS COMPANY

    Brake Caliper Guide Pin Bolt (1) - Install and tighten40 N.m (30 lb ft) [2x]

  3. GM4231237Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Install NEW brake hose fitting gaskets.

    Brake Hose Fitting Gasket (1) @ Brake Hose Fitting (2) - Install [2x]

  4. GM4231232Courtesy of GENERAL MOTORS COMPANY

    Brake Hose Fitting Bolt (1) - Install and tighten 40 N.m (30 lb ft)

  5. Install the park brake cable to the brake caliper actuator lever. - Parking Brake Rear Cable Replacement - Left Side , Parking Brake Rear Cable Replacement - Right Side
  6. Bleed the brake system. Hydraulic Brake System Bleeding (Pressure)Hydraulic Brake System Bleeding (Manual)
  7. Tire and Wheel Removal and Installation - Install