Installation Procedure
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Prepare the brake caliper bracket bolts and the bracket threaded holes for assembly:
- Thoroughly clean the residue from the bolt threads with denatured alcohol or equivalent and allow to dry.
- Thoroughly clean the residue from the threaded holes with denatured alcohol or equivalent and allow to dry.
- Apply threadlocker to 2/3 of the threaded length of the bolts. Adhesives, Fluids, Lubricants, and Sealers
Rear Brake Caliper Bracket (1) - Install
- CAUTION:
Brake Caliper Bracket Bolt (1) - Install and tighten [2x]
- First Pass:100 N.m (74 lb ft)
- Final Pass:15 - 30 degrees
Caliper Guide Pin Seal (1) - Install [2x]
- Apply a thin coat of high-temperature silicone brake lubricant to the caliper guide pins.
- NOTE:
The lower caliper guide pin is equipped with a bushing and must be installed in the same location.
Caliper Lower Guide Pin (1) - Install
Caliper Upper Guide Pin (1) - Install
- Rear Disc Brake Pad - Remove - Rear Disc Brake Pads Replacement (Without J71) Rear Disc Brake Pads Replacement (With J71)
- Install the rear tire and wheel assembly. Tire and Wheel Removal and Installation