Installation Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Power Brake Booster (1) - Install
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Fastener Caution

Power Brake Booster Bolt (1) - Tighten 19 N.m (14 lb ft) [2x]
Courtesy of GENERAL MOTORS COMPANY

Power Brake Booster Vacuum Sensor (1) - Install
Power Brake Booster Vacuum SensorElectrical Connector - Connect
Courtesy of GENERAL MOTORS COMPANY

Power Brake Booster Vacuum Pipe Fitting (1) @Power Brake Booster Vacuum Sensor - Connect
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Install a NEW brake pedal retainer.

Retainer (1) - Install
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Ensure the locking tabs on the brake pedal retainer are fully engaged in the brake pedal arm.

Brake Pedal (1) - Connect
Electronic Traction Control Brake Pressure Modulator Valve Replacement - Install
Brake Master Cylinder Replacement (Without HP4) , or Brake Master Cylinder Replacement (With HP4) - Install