LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Hydraulic Brake System) >> Repair Instructions >> Front Brake Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Brake Dust Warning

WARNING:

Brake Fluid Irritant Warning

  1. Raise and support the vehicle. Lifting and Jacking the Vehicle
  2. Remove the tire and wheel assembly. Tire and Wheel Removal and Installation
  3. GM4235921Courtesy of GENERAL MOTORS COMPANY

    Brake Pipe Fitting (1) - Disconnect

  4. Cap the brake pipe fitting to prevent brake fluid loss and contamination.
  5. GM4235931Courtesy of GENERAL MOTORS COMPANY

    Brake Hose Retainer (1) - Remove

  6. GM4213881Courtesy of GENERAL MOTORS COMPANY

    Wheel Speed Sensor Harness Clip (1) @Front Brake Hose - Release [2x]

  7. GM4235929Courtesy of GENERAL MOTORS COMPANY

    Brake Hose Bracket Bolt (1) - Remove

  8. GM4216968Courtesy of GENERAL MOTORS COMPANY

    Brake Hose Fitting Bolt (1) - Remove

  9. GM4216970Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Do NOT reuse the brake hose fitting gaskets.

    Brake Hose Fitting Gasket (1) @ Brake Hose Fitting (2) - Remove and DISCARD [2x]

  10. Plug the caliper inlet to prevent brake fluid loss and contamination.
  11. Remove the brake hose.
scientia non olet · About LEMON Manuals