LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Hydraulic Brake System) >> Diagnostic Information and Procedures >> DTC P25C6 or P25C7 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition - On / Vehicle - In Service Mode
  2. Verify DTC P25C6, P25C7 is not set.
    • If the DTC is set 
    1. Perform all necessary programming and setup procedures for the control module:K177 Brake Booster Control Module
    2. Verify the DTC does not set.
      • If the DTC sets - Replace the component:K177 Brake Booster Control Module
      • Go to next step: If the DTC is not set
    3. All OK.
    • Go to next step: If the DTC is not set 
  3. All OK.
scientia non olet · About LEMON Manuals