LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Hydraulic Brake System) >> Diagnostic Information and Procedures >> DTC C0299 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition - On / Vehicle - In Service Mode
  2. Verify DTC P0556, P0557, P0558 is not set.
    • Go to next step: If the DTC is not set 
  3. Verify the brake booster vacuum system has none of the conditions listed below:
    • Vacuum leak
    • Damaged, defective, or loose component:
    • Go to next step: If no condition exists
  4. Test or replace the component: B19B Brake Booster Vacuum Sensor
  5. Ignition - On / Vehicle - In Service Mode
  6. Verify the DTC does not set.
    • If the DTC sets 

      Replace the component:K17 Electronic Brake Control Module

    • Go to next step: If the DTC does not set
  7. All OK.