Removal Procedure
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Fold down rear seat back cushion to gain access.
Rear Compartment Side Trim (2) - Remove - Rear Compartment Side Trim Replacement - Left Side (With HP4)
Drive Motor Battery Cooling Air Outlet Duct Retainer (1) - Remove
- Drive Motor Battery Cooling Air Outlet Duct (2) - Remove
Drive Motor Generator Control Module Tray Retainer (1) - Remove [2x]
- Un-clip the drive motor generator control module tray.
- Drive Motor Generator Control Module Tray (2) - Remove
Drive Motor Battery Cooling Bracket Nut (1) - Remove [2x]
Remove the wiring harness from the upper drive motor battery bracket stud.
- Drive Motor Battery Cooling Bracket Nut (1) - Remove [3x]
- Detach the battery cable from the drive motor battery bracket and disconnect the drive motor battery cooling blower electrical connector.
Drive Motor Generator Battery Bracket (1) - Remove
Drive Motor Generator Battery Cooling Air Inlet Duct Retainer (1) - Remove [2x]
- Drive Motor Battery Cooling Blower Inlet Duct (2) - Remove
Drive Motor Battery Cooling Blower Bolt (1) - Remove [3x]
- Drive Motor Generator Battery Cooling Blower (3) @ Drive Motor Generator Battery Bracket (2) - Remove