Installation Procedure
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Drive Motor Generator Power Inverter Module Pump Cooling Inlet Hose (2) @ Drive Motor Battery Radiator Surge Tank - Install
- Generator Control Module Coolant Pump Hose Clamp (1) - Engage - Hose Clamp Replacement Guidelines - Spring Type
- Maneuver the drive motor battery radiator surge tank (3) into the coolant temperature system control module bracket.
- CAUTION:
Refer to Fastener Caution .
Drive Motor Battery Radiator Surge Tank Bolt (6) - Install and tighten 9 N.m (80 lb in)
- Drive Motor Battery Radiator Surge Tank Bolt (5) - (Double Studded) - Install and tighten 9 N.m (80 lb in)
- Engine Wiring Harness Clip (4) - Install
- Engine Wiring Harness Clip Nut (3) - Install and tighten 9 N.m (80 lb in)
- Drive Motor Power Inverter Module Cooling Outlet Hose (2) @ Drive Motor Battery Radiator Surge Tank - Install
- Generator Control Module Coolant Pump Hose Clamp (1) - Engage - Hose Clamp Replacement Guidelines - Spring Type
- Fill the drive motor generator power inverter module cooling system. Drive Motor Generator Power Inverter Module Cooling System Draining and Filling
- Inspect for coolant leaks.