Installation Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Drive Motor Battery Cooling Blower Inlet Duct (2) - Install
Drive Motor Generator Battery Cooling Air Inlet Duct Retainer (1) - Install [2x]
Courtesy of GENERAL MOTORS COMPANY

Drive Motor Generator Battery Bracket (1) - Install
Connect the drive motor battery cooling blower electrical connector and attach the battery cable to the drive motor battery bracket.
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Drive Motor Battery Cooling Bracket Nut (1) - Install and tighten [3x] - Drive Motor Generator Battery Bracket Replacement (Drive Motor Generator Battery Cooling Blower) , or Drive Motor Generator Battery Bracket Replacement (Drive Motor Battery Radiator Surge Tank)
Install the wiring harness onto the upper drive motor battery bracket stud.
Courtesy of GENERAL MOTORS COMPANY

Drive Motor Battery Cooling Bracket Nut (1) - Install and tighten [2x] Drive Motor Generator Battery Bracket Replacement (Drive Motor Generator Battery Cooling Blower) , or Drive Motor Generator Battery Bracket Replacement (Drive Motor Battery Radiator Surge Tank)
Courtesy of GENERAL MOTORS COMPANY

Drive Motor Generator Control Module Tray (2) - Install
Clip the drive motor generator control module tray.
Drive Motor Generator Control Module Tray Retainer (1) - Install [2x]
Courtesy of GENERAL MOTORS COMPANY

Drive Motor Battery Cooling Air Outlet Duct (2) - Install
Drive Motor Battery Cooling Air Outlet Duct Retainer (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Rear Compartment Side Trim (2) - Install - Rear Compartment Side Trim Replacement - Left Side (With HP4)
Raise the rear seat back cushion.