Installation Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

NOTE:
Take care not to damage duct seal (2), when installing.

Battery Cooling Air Inlet Duct - Rear (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Battery Hold Down Retainer - Left Side Panel (3) - Install

CAUTION:

Refer to Fastener Caution

Battery Hold Down Retainer Nut (1) - Install and tighten [4X] 9 N.m (80 lb in)
Install the cell battery vent tube grommet (2) to the top of the battery hold down retainer.
Courtesy of GENERAL MOTORS COMPANY

Battery Hold Down Retainer - Right Side Panel (3) - Install
Battery Hold Down Retainer Nut (1) - Install and tighten [4X] 9 N.m (80 lb in)
Wiring Harness Retainer (2) - Engage
Courtesy of GENERAL MOTORS COMPANY

Battery Cover - Front (3) - Install - Battery Cover Replacement (Front Panel)
Courtesy of GENERAL MOTORS COMPANY

Battery Cover - Back (2) - Install - Battery Cover Replacement (Back Panel)
Courtesy of GENERAL MOTORS COMPANY

High Voltage Battery Tray Reinforcement - Right Side (1) - Install - High Voltage Battery Tray Reinforcement Replacement (Right Side)
Courtesy of GENERAL MOTORS COMPANY

High Voltage Battery Tray Reinforcement - Left Side (1) - Install - High Voltage Battery Tray Reinforcement Replacement (Left Side)
Courtesy of GENERAL MOTORS COMPANY

High Voltage Battery (1) - Install - High Voltage Battery Replacement and Shipping Preparation
Enable the high voltage system. High Voltage Enabling