Removal Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Disable the high voltage system. High Voltage Disabling
Courtesy of GENERAL MOTORS COMPANY

High Voltage Battery (1) - Remove - High Voltage Battery Replacement and Shipping Preparation
Courtesy of GENERAL MOTORS COMPANY

High Voltage Battery Tray Reinforcement - Left Side (1) - Remove - High Voltage Battery Tray Reinforcement Replacement (Left Side)
Courtesy of GENERAL MOTORS COMPANY

High Voltage Battery Tray Reinforcement - Right Side (1) - Remove - High Voltage Battery Tray Reinforcement Replacement (Right Side)
Courtesy of GENERAL MOTORS COMPANY

Battery Cover - Front (3) - Remove - Battery Cover Replacement (Front Panel)
Courtesy of GENERAL MOTORS COMPANY

Battery Cover - Back (2) - Remove - Battery Cover Replacement (Back Panel)
Courtesy of GENERAL MOTORS COMPANY

Disengage the cell battery vent tube grommet (2) and reposition away.
Battery Hold Down Retainer Nut (1) - Remove [4X]
Battery Hold Down Retainer - Left Side Panel (3) - Remove
Courtesy of GENERAL MOTORS COMPANY

Wiring Harness Retainer (2) - Disengage
Battery Hold Down Retainer Nut (1) - Remove [4X]
Battery Hold Down Retainer - Right Side Panel (3) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Take care not to damage duct seal (1) when removing.

Battery Cooling Air Inlet Duct - Front (2) - Remove