Installation Procedure
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Apply pressure on the piston (1) to release tension from the pawl (3).
- Rotate the lever (2) counter-clockwise.
- Push the piston (1) inward until fully depressed, then release the lever (2).
Slowly relieve tension from the piston (1) until it extends three clicks.
- Install a suitable pin (2) as shown to lock the tensioner.
Timing Chain Tensioner Gasket (3) - Install NEW
- Timing Chain Tensioner (2) - Install
- Timing Chain Tensioner Bolt (1) - Install and tighten [2x] 25N.m (18 lb ft)
- Remove the tensioner locking pin.
- Engine Front Cover - Install - Engine Front Cover Replacement
CAUTION:
Refer to Fastener Caution .