LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Engine Mechanical - 2.0L (LTG)) >> Repair Instructions - On Vehicle >> Intake Valve Rocker Arm Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM1825091Courtesy of GENERAL MOTORS COMPANY

    Lubricate the valve tips. Refer to Adhesives, Fluids, Lubricants, and Sealers .

  2. GM2963895Courtesy of GENERAL MOTORS COMPANY
    NOTE:
    • Used rocker arms must be returned to the original position on the camshaft. If the camshaft is being replaced, the rocker arms actuated by the camshaft must also be replaced.
    • Pre-oil roller bearings before installation.

    Lubricate the roller bearings with valve rocker arm lubricant. Refer to Adhesives, Fluids, Lubricants, and Sealers .

  3. Position the valve rocker arm (1) on the tip of the valve stem and on the lash adjuster and lubricate. Refer to Adhesives, Fluids, Lubricants, and Sealers .
  4. Install the camshaft position actuator and camshaft - intake. Refer to Camshaft Position Actuator and Camshaft Replacement - Intake .
scientia non olet · About LEMON Manuals