Installation Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

For ease of installation, all engine mount bolts should be hand started prior to performing final tightening steps.

Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

CAUTION:
Refer to Torque-to-Yield Fastener Caution .

NOTE:
Install NEW bolts.

Position the engine mount (2) then hand start the NEW bolts (1).

Tighten
1. First Pass:100 N.m (74 lb ft)
2. Final Pass:75 degrees
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Install NEW bolts.

Hand start NEW engine mount to engine mount bracket bolts (1).
With the mount fasteners hand tightened, release the tension from the engine support fixture.
1. Shake the powertrain vigorously by hand to allow the powertrain to settle.
Tighten the NEW engine mount to engine mount bracket bolts (1).
Tighten
1. First Pass:100 N.m (74 lb ft)
2. Final Pass:75 degrees
Courtesy of GENERAL MOTORS COMPANY

Engine Mount Brace (3) - Install
Engine Mount Brace Nut (1) - Install and tighten 22 N.m (16 lb ft)
Engine Mount Brace Bolt (2) - Install and tighten 22 N.m (16 lb ft)
Engine Support Fixture - Remove - Engine Support Fixture
Air Cleaner Assembly - Install - Air Cleaner Assembly Replacement
Intake Manifold Cover - Install - Intake Manifold Cover Replacement