Installation Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Install the crankshaft balancer with NEW fastener. Use EN-51577-1 Crankshaft Balancer Remover (1) and breaker bar (2) prevent the crankshaft from rotating while tightening the NEW crankshaft balancer fastener (3).

CAUTION:

Refer to Fastener Caution .

Tighten the crankshaft balancer bolt to 150 N.m (111 lb ft) plus an additional 140 degrees using the EN-45059 meter.
Install the drive belt. Drive Belt Replacement
Perform the crankshaft position variation learn procedure. Crankshaft Position Variation Learn