Installation Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Slide a NEW crankshaft rear oil seal (2) over the EN-51151 - 1 installer (1) onto the EN-51151 - 2 installer (3).
Courtesy of GENERAL MOTORS COMPANY

Remove the EN-51151 - 1 installer (1).
Install the EN-523 - 1 handle (3) to the EN-51151 - 2 installer (2).
Courtesy of GENERAL MOTORS COMPANY

Install the crankshaft rear oil seal ring using the EN-51151 - 2 installer (3) along with the EN-523 - 1 handle (1) to the crankshaft rear oil seal housing (2).
Clean the crankshaft rear oil seal housing sealing surfaces.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
The complete installation procedure of the crankshaft rear oil seal housing must be fitted within 10 minutes of applying the sealing compound. DO NOT coat sealing compound into the crankshaft rear oil seal housing bolt bores and threads.

Apply approximately a 3.0 mm (0.12 in) thick bead of sealant (1) to the crankshaft rear oil seal housing (2). Adhesives, Fluids, Lubricants, and Sealers
Courtesy of GENERAL MOTORS COMPANY

Apply additional sealant (1, 2) to the transitions between the cylinder block and the lower crankcase in the shown area.
Courtesy of GENERAL MOTORS COMPANY

Crankshaft Rear Oil Seal Housing (1) - Install
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

NOTE:
Install bolts in previously marked positions.

Crankshaft Rear Oil Seal Housing Bolt (1) - Install and tighten [6x] 10 N.m (89 lb in).

NOTE:

Install bolts in previously marked positions.

Crankshaft Rear Oil Seal Housing Bolt (2) - Install and tighten [4x] 10 N.m (89 lb in).
Crankshaft Position Sensor - Install - Crankshaft Position Sensor Replacement
Automatic Transmission Flex Plate Replacement - Install