Installation Procedure
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Install the NEW crankshaft front oil seal (1) to the EN-51152 installer (2).
Using the EN-51152 installer (1), install the crankshaft front oil seal to the engine front cover.
- Install the J-44389-2 forcing screw (2) and tighten.
- Remove the J-44389-2 forcing screw (2) and EN-51152 installer (1).
Ensure that the crankshaft front oil seal (1) flushes with the engine front cover (2).
- Crankshaft Balancer Absorber - Install - Crankshaft Balancer Absorber Replacement
- Remove the drain pan.
- Check and correct the engine oil level. For engine oil specifications, refer to Engine Mechanical Specifications .