Fuel Injection Fuel Feed Front Pipe Installation
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Install the fuel injection fuel feed pipe (3) to the fuel rail (1) and to the fuel injection pump (6)..
- Install the 2 nuts (2, 5) and tighten to 30 N.m (22 lb ft).
- Install the fuel injection fuel feed pipe bracket bolt (4) and tighten to 10 N.m (89 lb in).
- Perform a fuel rail assembly leak test.
- Start the engine.
- Check the engine for escaping fuel.
CAUTION:
Refer to Fastener Caution .
WARNING:
Fuel escapes - observe safety measures and national legislation. Failure to comply could result in personal injury.
WARNING:
Always wear safety goggles when working with fuel in order to protect the eyes from fuel splash.
NOTE:
Ensure that all work at the engine is finished.