Engine Block Disassemble

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Remove the 2 cylinder guide sleeves (1).
Remove the crankshaft rear oil seal housing locating pin (2).
Remove the 2 transmission locating pins (3).
Remove the engine block oil gallery plugs (4, 5).
Courtesy of GENERAL MOTORS COMPANY

Remove the engine oil pressure sensor (2).
Remove and DISCARD the engine oil pressure sensor seal (1).
Remove the 3 oil pump flow control valve bolts (4).
Remove the oil pump flow control valve (5).
Remove an DISCARD the oil pump flow control valve seal (3).
Remove the knock sensor bolt (6).
Remove the knock sensor (7).
Courtesy of GENERAL MOTORS COMPANY

Remove the engine coolant heater (2), if equipped.
Remove and DISCARD the engine coolant heater seal (1).
Courtesy of GENERAL MOTORS COMPANY

Remove the engine coolant heater hole plug (1), if equipped.
Clean the threads.
Courtesy of GENERAL MOTORS COMPANY

Remove the 4 piston oil nozzles bolts (2).
Remove the 4 piston oil nozzles (1).
Remove the lower crankcase locating pin (3).
Courtesy of GENERAL MOTORS COMPANY

Remove the engine block oil gallery plug (1).
Remove the engine front cover bolt guide (2).
Remove the oil pump bolt guide (3).