LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Engine Mechanical - 1.5L (LFV)) >> Repair Instructions - On Vehicle >> Turbocharger Oil Feed Pipe Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Air Conditioning Compressor Bracket Replacement (LFV) - Remove
  2. GM3979896Courtesy of GENERAL MOTORS COMPANY

    Remove the turbocharger oil feed pipe bolt (1).

  3. Remove and DISCARD the 2 turbocharger oil feed pipe gaskets (2).
  4. Raise and support the vehicle. - Lifting and Jacking the Vehicle
  5. GM3764371Courtesy of GENERAL MOTORS COMPANY

    Remove the turbocharger oil feed pipe clip (1).

  6. Remove and DISCARD the turbocharger oil feed pipe retainer (3).
  7. NOTE:

    It is necessary to remove the catalytic converter to gain more space for the turbocharger oil feed pipe removal.

  8. Warm Up Three-Way Catalytic Converter Replacement (LFV) - Remove
  9. Remove the turbocharger oil feed pipe (2).
  10. GM3764374Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    The turbocharger oil feed pipe fitting is not reusable.

    Remove and DISCARD the turbocharger oil feed pipe fitting (2).

  11. Remove and DISCARD the turbocharger oil feed pipe fitting gasket (1).