Installation Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Reposition both floor jacks and blocks of wood in order to allow a 1/8 inch gap between the mount and bracket.
Shake the powertrain vigorously by hand from front to rear and allow the powertrain to settle.
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Tighten the engine mount to engine mount bolts (1). Engine Mount Replacement
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Bolts (1) should remain tightened during the balancing procedure.

Tighten the transmission mount transmission side bolts (2) at the left transmission mount (3). Transmission Mount Replacement (Left Side)
Raise the vehicle. Lifting and Jacking the Vehicle
Remove the jack stands and wood blocks supporting the engine and transaxle from underneath the powertrain.
Lower the vehicle. Lifting and Jacking the Vehicle