Removal Procedure
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the drive belt. Water Pump, Air Conditioning Compressor, and Generator Belt Replacement
Use EN-44226-1 Crankshaft Balancer Holder/Remover (1) and ratchet (2) prevent the crankshaft from rotating while loosening the crankshaft balancer fastener (3).
- Remove and DISCARD the crankshaft balancer fastener (3).
Remove the crankshaft balancer holder then install the EN-44226-5 Crankshaft End Protector (1) and all components of EN-44226-1 Crankshaft Balancer Holder/Remover (2, 3) as shown.
Tighten the crankshaft balancer remover (1) in order to remove the crankshaft balancer (2).