Crankshaft Balancer Removal

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Install the EN-51760 holder, lock the automatic transmission flex plate via the starter ring gear. Special Tools EN-51760 Flywheel HolderFor equivalent regional tools, refer to Special Tools .
1	Crankshaft Balancer Bolt
2	Crankshaft Balancer Procedure Install the EN-44226-5 protector onto the crankshaft. Install EN-44226-1 holding body and EN-44226-2 remover plate with remover bolt onto the balancer. Counter hold the EN-44226-2 remover plate and turn the remover screw to remove the balancer. Special Tools EN-44226 Crankshaft Balancer Remover EN-44226-5 Crankshaft Protector

Callout

Component Name

Preliminary Procedure

Install the EN-51760 holder, lock the automatic transmission flex plate via the starter ring gear.

Special Tools EN-51760 Flywheel HolderFor equivalent regional tools, refer to Special Tools .

Crankshaft Balancer Bolt

Crankshaft Balancer

Procedure

Install the EN-44226-5 protector onto the crankshaft.
Install EN-44226-1 holding body and EN-44226-2 remover plate with remover bolt onto the balancer.
Counter hold the EN-44226-2 remover plate and turn the remover screw to remove the balancer.

Special Tools

EN-44226 Crankshaft Balancer Remover
EN-44226-5 Crankshaft Protector