LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Engine Mechanical - 1.5L (LFV)) >> Repair Instructions - Off Vehicle >> Crankshaft Balancer Installation

Crankshaft Balancer Installation

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
GM3600370Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Install the EN-51760  holder, lock the automatic transmission flex plate via the starter ring gear.
Special Tools 
EN-51760  Flywheel Holder
For equivalent regional tools, refer to Special Tools .
1 Crankshaft Balancer
Procedure 
Using the screw, washer, bearing, and nut from the EN-51368  installer, seat the crankshaft balancer.
Special Tools 
EN-51368  Front Crankshaft Seal Installer
For equivalent regional tools, refer to Special Tools .
2 Crankshaft Balancer Bolt
CAUTION:

Refer to Fastener Caution .

CAUTION:

Refer to Torque-to-Yield Fastener Caution .


Procedure 
Tighten the NEW crankshaft balancer bolt in the sequence shown.
  1. Tighten the bolt a first pass to 100 N.m (74 lb ft).
  2. Loosen the bolt 360 degrees.
  3. Tighten the bolt a second pass to 100 N.m (74 lb ft).
  4. Tighten the bolt a final pass 180 degrees using EN-45059  angle meter.
  5. Remove EN-51760  holder once final torque is achieved.

Special Tools 
EN-45059  Angle Meter
For equivalent regional tools, refer to Special Tools .
scientia non olet · About LEMON Manuals