Installation Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Engine Coolant Fan Electrical Connector (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Engine Coolant Fan Electrical Connector (1) @ Engine Coolant Fan - Connect
Courtesy of GENERAL MOTORS COMPANY

Engine Coolant Fan Wiring Harness (2) @ Engine Coolant Fan (1) - Clip
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Install the ground terminal (3) onto the ground stud.
Ground Nut (2) - Install - Ground Repair
Connect the engine cooling fan wiring harness connectors (1) to the engine wiring harness.
Courtesy of GENERAL MOTORS COMPANY

Wiring Harness Clip (1) @ Transmission Fluid Cooler Inlet PipeClip
Electrical Connector (2) @ Generator Control Module Coolant Pump - Connect
Courtesy of GENERAL MOTORS COMPANY

Electrical Connector @ Engine Coolant Temperature Sensor (2) @ Auxiliary Radiator - Connect
Wiring Harness Retainer (1) @ Radiator - Clip
Courtesy of GENERAL MOTORS COMPANY

Wiring Harness Retainer (2) @ Radiator - Clip
Wiring Harness Clip (4) @ Air Conditioning Evaporator Tube - Clip
Electrical Connector @ Air Conditioning Refrigerant Pressure Sensor (3) - Connect
Electrical Connector @ Engine Coolant Temperature Sensor (1) - Connect
Connect all electrical connectors.
Courtesy of GENERAL MOTORS COMPANY

Front Bumper Fascia (4) - Install - Front Bumper Fascia Replacement
Courtesy of GENERAL MOTORS COMPANY

Drive Motor Generator Battery Bracket - Install - Drive Motor Generator Battery Bracket Replacement (Drive Motor Generator Battery Cooling Blower) , or Drive Motor Generator Battery Bracket Replacement (Drive Motor Battery Radiator Surge Tank)