Removal Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Front Bumper Fascia (1) - Remove - Front Bumper Fascia Replacement
Disconnect all electrical connectors.
Courtesy of GENERAL MOTORS COMPANY

Electrical Connector @ Engine Coolant Temperature Sensor (1) - Disconnect
Electrical Connector @ Air Conditioning Refrigerant Pressure Sensor (2) - Disconnect
Unclip the engine coolant fan wiring harness from the vehicle indicated by the arrows.
Courtesy of GENERAL MOTORS COMPANY

Electrical Connector @ Turbocharger Air Pressure Sensor (1) - Disconnect
Unclip the engine coolant fan wiring harness from the vehicle indicated by the arrows.
Courtesy of GENERAL MOTORS COMPANY

Disconnect the engine cooling fan wiring harness connectors (1) from the engine wiring harness.
Ground Nut (2) - Remove
Remove the ground terminal (3) from the ground stud.
Courtesy of GENERAL MOTORS COMPANY

Engine Coolant Fan MotorWiring Harness (2) @ Engine Coolant Fan Shroud (1) - Unclip
Courtesy of GENERAL MOTORS COMPANY

Electrical Connector @ Engine Coolant Fan Motor (1) - Disconnect
Courtesy of GENERAL MOTORS COMPANY

Maneuver the engine coolant fan wiring harness (1) out from the engine compartment.