Circuit/System Verification
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON.
- Verify the G10 Cooling Fan Motor activates in each available speed when commanding the cooling fan ON with a scan tool. The cooling fan speed should increase with each command.
- The cooling fan does not activate or increase in speed as commanded
Refer to Circuit/System Testing
- Go to next step: The cooling fan activates and increases in speed as commanded
- The cooling fan does not activate or increase in speed as commanded
- Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Refer to Circuit/System Testing
- Go to next step: If the DTC does not set
- If the DTC sets
- All OK.
NOTE:
A slight delay may occur before the cooling fan activates.