Component Testing
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF.
- Disconnect the G10 Cooling Fan Motor harness connector from the G10 Cooling Fan Motor.
- Connect the EL 36169 - HD between the G10 Cooling Fan Motor terminal 1 and B+. Connect a jumper wire between the G10 Cooling Fan Motor terminal 2 and ground.
- Verify the G10 Cooling Fan Motor operates.
- The cooling fan does not operate
Replace the G10 Cooling Fan Motor.
- Go to next step: The cooling fan operates
- The cooling fan does not operate
- All OK.